Skip to content
  • There are no suggestions because the search field is empty.

17 Emission (Clone)

17.1 lonizing Radiations

This machine's radiation emissions are only electromagnetic low frequency type.

Test measure was done to demonstrate that radiation levels are within the allowed range specified in directive 2006/42/EC, please check the table below.

17.2 Not ionizing Radiations

The emission level for not ionizing radiations are negligible so it does not represent a risk for machine users.

17.3 Vibrations

If the machine is used in the right conditions and the maximum rating is respected, the vibrations level is low and not represent a danger.

17.4 Noise Emission

  1. The machine was checked for noise level based on actual norms.
  2. Noise level during normal work condition is not over 80dB.
  3. Particular care must be taken when air gun is used, the air gun can generate high noise level peak so ear protectors and safety glasses must be used.
  4. In case of not normal machine noise, it is highly recommended to call immediately the authorized technical service company.
  5. Values of areal noise produced by the machine, according to section 1.7.4.2 (u) ANNEX 1 of 2006/42/EC DIRECTIVE.

Measuring method : ISO 11202:1997

  • The measuring positions is four, as shown on drawing and is taken at 1600mm from the floor and at 1000mm from the machine.
  • The machine is completely closed with covers.
  • Spindle rotation at maximum speed. (not cutting)

NOTE

  1. The noise values indicated are emission levels and they don't represent absolute safe level.
  2. The relation that exists between exposition and emission level can't be reliably used to prove that a specific protection must be used.
  3. The operator exposition level must consider the time of exposition, the acoustic behavior of the room and finally the presence of other noise source (ex. other machines near the operator).
  4. The exposition level can be different for different country.
  5. This information is useful primary for a proper evaluation of risk and danger to which the operator is exposed.

17.5 Electromagnetic Emission

The machine was built for working in electromagnetic environment of industrial type (environment type A as defined in EN 60439-1, net and not public place or low voltage industrial environment).

  1. This machine is for environment of type A. In domestic environment this product can generate interference in radio frequency range, the final user must take care of this fact and find the right solution or require for a special execution to the machine's manufacturer.
  2. The conformity to maximum level of immunity and emission in case of industrial environment is obtained by the application of product harmonized technical norm.